Research journal

A dated record of work in progress.

Entries are published after technical review and describe what happened, what was learned and what remains open. Nothing here is a performance claim.

5 entries published | 2026 programme

PROGRAMME LOG · 2026 SECTION STUDY

Illustrative drafting sheet. Imagery is only published where technical review has approved it.

Timeline of entries

Programme log, newest last.

Categories: Programme, Mentorship, Kinematics, Manufacturing, Funding.

September 2026 Programme

Research initiation and baseline definition

The programme was initiated by Atharva Satpute at VNIT Nagpur under the academic guidance of Dr. A. K. Singh. Literature review, candidate aerodynamic baselines and CAD modelling established the starting geometry for mechanism work.

Literature review AERY32 baselines CAD
2 October 2026 Mentorship

Industry mentorship and engineering development discussions

Discussions with industry practitioners covered practical engineering development paths, fabrication realities and the questions a morphing wing programme has to answer before hardware is attempted.

Mentorship Engineering review
4 October 2026 Kinematics

Mechanism simulation, kinematic data and preliminary report

Candidate four-bar configurations were evaluated in kinematic simulation. Position data, transmission-angle behaviour and rocker motion were recorded, and the findings were consolidated into a preliminary technical report.

MechSim Kinematic data Report
10 October 2026 Manufacturing

Manufacturing visit: laser cutting, power press and CNC bending

A workshop review of available processes established what tolerances and finishes a first demonstrator can realistically achieve, and which components are better machined than formed.

Fabrication Process review
16 October 2026 Funding

Initial funding approved for design and prototyping

Initial funding was approved for further design and prototyping activity. The amount is not disclosed. The support is directed at mechanism development and demonstrator fabrication.

Prototyping Programme support

How entries are published

An entry is added after the underlying work has been reviewed. Unpublished calculations, raw simulation data, CAD files and mechanism dimensions are not released. Funding figures remain private unless the programme chooses otherwise.

Next entries

Future updates will cover mechanism refinement, simulation results and the first demonstrator build. Approved captures from simulation work are available in the media section.

Open media & simulations